All FAQs (1734 total: showing 81-100)
- Do cables need to be trenched from the sensors to the automated monitoring system?
- Does an automated monitoring system need to have AC power?
- For an automated monitoring system, what type of sensors can be automated?
- Which countries will the AeroX Stream 200 work in?
- What communication options can be used with the AeroX Stream 200?
- What types of sensors will work with the AeroX Stream 200?
- When the Burst Mode operation is used with the Volt 108 or Volt 116, what happens?
- What is the fastest speed at which the Volt 108 or Volt 116 can operate?
- Why are single-ended measurements used in the ACPower() instruction in CRBasic when the outputs of the potential transformer and current transformer are inherently differential?
- Does the mast of the CM375 have any lightning protection?
- If duckbill anchors cannot be used to stabilize the CM375 in uneven, rocky terrain, what should be used instead?
- Can the base plate of the CM375 be fixed to the ground to improve stability, especially in rocky, mountainous areas?
- Can the mast and the guy cables of the CM375 support ice loading?
- Under what temperature conditions can the CM375 operate?
- What is the probable life expectancy of the CM375 mast?
- Is the CS241 recommended for use at the back or the front of the bifacial module?
- For the standard (non-NIST) version of the CS240 sensors, how does Campbell Scientific verify the ability of the sensors to measure and that the measurements made are calibrated to provide correct measurements?
- What are the differences between the different turbidity units used, such as NTU, FBU, FTU, and FNU?
- What is the difference between the backscatter measurement of the OBS-3+ and the side-scatter measurement of the ClariVue™10 sensor?
- How can data from LoggerNet be added into the SCADA software OSIsoft PI?
Previous
Next