FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1734 total: showing 921-940)

How do the AM25T and the AM16/32B compare with regard to relay wear and tear?
How do the AM25T and the AM16/32B compare with regard to low-level mV signals?
How do the AM25T and the AM16/32B compare with regard to resistive bridge measurements?
How do the AM25T and the AM16/32B compare with regard to thermocouple measurements?
Does the CS210 need to be regularly replaced?
Does the CS210 require any regular maintenance?
What relative humidity (RH) reading from a CS210 would indicate that it is time to replace the desiccant packs in the enclosure?
What might cause the CS210 to report negative data?
Can the CS210 be connected to a multiplexer?
If the top section of a UT30 gets damaged, can just that section be replaced?
Can the anchor for the UT30 be set alone—without using the bottom 10 ft piece as a guide?
If the paper bag with the UT30 hardware gets lost, how can the hardware pieces be replaced?
Do Campbell Scientific dataloggers directly support the LonWorks communications protocol?
Do Campbell Scientific dataloggers directly support the Profibus communications protocol?
Do Campbell Scientific dataloggers directly support the BACnet communications protocol?
Can multiple SP10 solar panels be used together?
Is a regulator needed with an SP5, SP10, SP10-PW, SP20, or SP20-PW?
Would there be any issues with installing 900 MHz wireless devices at stations that use 900 MHz radios for communication? Would this cause too much noise interference?
What should be done if the content of a water source to be sampled is unknown?
To determine how much tubing is needed to cover the distance from a water sampler to the water source, how is slope length calculated?

Previous Next